Hyundai Azera: Blower

Mode Control Actuator Repair procedures

Inspection 1. Ignition "OFF” 2. Disconnect the connector of mode control actuator. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to the termin ...

Blower Unit Components and Components Location

Component Location Components 1. Duct Seal2. Duct Case3. Inlet Door4. Intake Actuator5. Inlet Duct Case (A)6. Climate control air filter7. Cluster Ionizer8. Climate control air filter Cover9. Bl ...

See also:

Front Hub - Axle Repair procedures
Replacement 1. Loosen the wheel lug nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire(A) from front hub. Tightening torque: 88.2 ...

Engine Coolant Temperature Sensor (ECTS) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS (Refer to "Removal"). 4. After immersing the thermistor of the sensor into engine coola ...

Seat Heater Switch Repair procedures
Inspection Front Seat Heater Switch 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor Console Assembly") 3. Remove the sea ...