Hyundai Azera: Controller

Intake Actuator Repair procedures

Inspection 1. Ignition "OFF". 2. Disconnect the intake actuator connector. 3. Verify that the actuator operates to the recirculation position when connecting 12V to the terminal 3 and grou ...

Heater & A/C Control Unit(Full Automatic) Components and Components Location

Components Connector pin function ConnectorPIN NoFunctionConnectorPIN NoFunctionConnector (A)1Tail (+)Connector (A)27Evaporator Sensor (+)2Sensor REF (+5V)28-3CAN HIGH29Incar Sensor (+)4CAN LOW30D ...

See also:

Trailing Arm Repair procedures
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     • Be careful not to damage to the hub bolt ...

Mode Control Actuator Description and Operation
Description The mode control actuator is located at the heater unit. It adjusts position of mode door by operating mode control actuator based on signal of A/C control unit. Pressing mode select ...

Dynamic Damper Repair procedures
Replacement 1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft�) 2. Remove the TJ joint assembly. (Refer to Driveshaft Assembly - “TJ Joint�) 3. ...