Hyundai Azera: Spark Plug Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Engine Electrical System / Ignition System / Spark Plug Repair procedures

Removal and Installation

1.	Remove the ignition coils. (Refer to Ignition System - "Ignition Coil")

2.

Using a spark plug socket, remove the spark plug.

Tightening torque :

14.7 ~ 24.5N.m (1.5 ~ 2.5kgf.m, 10.8 ~ 18.1lb-ft)

Be careful that no contaminates enter through the spark plug holes.

3.	Installation is reverse order of removal.

Inspection

1.

Inspect the electrodes (A) and ceramic insulator (B).

Inspection Of Electrodes

Condition

Dark deposits

White deposits

Description

-	Fuel mixture too rich

-	Low air intake

-	Fuel mixture too lean

-	Advanced ignition timing

-	Insufficient plug tightening torque

2.

Check the electrode gap (A).

Standard :

1.0 ~ 1.1 mm (0.0394 ~ 0.0433 in.)

Spark Plug Components and Components Location

Components 1. Spark plug ...

Charging System

...

See also:

Push-starting
Vehicles equipped with automatic transaxle cannot be push-started. Follow the directions in this section for jump-starting. WARNING - Tow starting vehicle Never tow a vehicle to start it beca ...

Rear combination light bulb replacement
(1) Stop and tail light (2) Rear turn signal light (3) Backup light (4) Rear side marker Stop/tail light and rear side marker If the light bulb does not operate, have the vehicle checked by an ...

On-board Refueling Vapor Recovery (ORVR) valve Repair procedures
Removal 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel tank. (Refer to Fuel System - "Fuel Tank") 3. Disconnect the vapor hose (A). 4. Remove ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com