Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Lift the vehicle. |
3. |
Disconnect the canister close valve connector (A). |
4. |
Disconnect the ventilation hose (B) from the fuel tank air filter and canister close valve. |
5. |
Remove the fuel tank air filter assembly after removing bolts (C). |
6. |
Release the lever (A), and then separate the canister close
valve (B) from the fuel tank air filter (C) after rotating it in the
direction of the arrow in the figure. |
Installation |
• |
Install the component with the specified torques. |
• |
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting. |
1. |
Installation is reverse of removal. |
Hood Latch Repair procedures
Replacement
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Detach the clips, then remove hood latch cover (A).
3.
Remove the hood latch (A) mounting b ...
Trunk
...
Engine Mounting Repair procedures
Removal and Installation
[Engine mounting support bracket]
1.
Install the jack to the edge of upper oil pan (A) to support the engine.
Insert the rubber block between jac ...