Inspection |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the rear package tray (A) after removing the rear seat.
|
3. |
Remove the rear curtain (A) after removing the connector and bolts (6EA). |
4. |
If necessary of removing the rear curtain motor (A), remove the screws (3EA). |
Installation |
1. |
Install the rear curtain and connector. |
2. |
Install the rear package tray and rear seat. |
3. |
Connect the negative (-) battery terminal. |
Rear Hub - Carrier Repair procedures
Replacement
1.
Loosen the wheel lug nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from front hub.
Tightening torque:
88. ...
TPMS Receiver Repair procedures
Replacement
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
2)
It will not be configured for any specific platform.
3)
It will not ha ...
Line Pressure Control Solenoid Valve Specifications
Specifications
Direct control VFS[LINE Pressure]
? Control type : Normal low type
Control Pressure [kpa (kgf/cm?, psi)]500.14 ~ 9.81(5.1~ 0.1, 72.54 ~ 1.42)Current value(mA)50 ~ 850 Inter ...