Hyundai Equus Manuals

Hyundai Azera: Rear Curtain Switch Repair procedures - Rear Curtain System - Body Electrical System - Hyundai Azera 2011-2025 Service ManualHyundai Azera: Rear Curtain Switch Repair procedures

Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the floor console upper cover.
3.
Remove the rear curtain switch connector (A) from the floor console upper cover.

4.
Remove the rear curtain switch assembly after loosining the screws (4EA).

Installation
1.
Install the floor console upper cover after installing the floor console upper cover switch.
2.
Install the negative(-) battery terminal.
Inspection
Inspection of a rear curtain
Auto up/down function
Initial condition
Inspection list
Normal value
1) IGN ON (DC 12V)
1) Rear curtain UP state
 - Rear curtain switch input(ON)
Rear curtain DOWN
2) Rear curtain DOWN state
 - Rear curtain switch input(ON)
Rear curtain UP
3) Rear curtain AUTO UP/DOWN activating
 - Rear curtain switch input(ON)
Reversal movement

Reverse interlocking function
Initial condition
Inspection list
Normal value
1) IGN ON(DC 12V)
2) Rear curtain UP
1) Transmission lever(P,D,N)->R
Rear curtain DOWN
2) Rear curtain DOWN by No.1)
 - Over 20 Km/h on the transmission lever D,N
- Below 20 Km/h on the transmission lever D,N
Rear curtain UP
Rear curtain DOWN
3) Rear curtain DOWN by No.1)
 - Transmission lever P
Rear curtain UP

? If a driver operates the rear curtain down by a rear curtain switch, the rear curtain doesn't do AUTO return.
Rear curtain switch inspeciton
1.
Inspect the rear curtain switch terminal. If necessary, replace the switch.

2.
Operate the switch and check for continuity between terminals.

Rear Curtain Repair procedures
Inspection Connect the battery voltage and check the rear curtain motor rotation. If the motor does not operate properly, substitute with a known-good rear curtain motor and check for proper op ...

Electro chromic Inside Rear View Mirror
...

See also:

CVVT Oil Control Valve (OCV) Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the OCV connector. 3. Measure resistance between the OCV terminals 1 and 2. 4. Check that the resistance is within the specifi ...

Fuel Pressure Control Valve (FPCV) Repair procedures
Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the fuel pressure regulator valve connector. 3. Measure resistance between the fuel ...

TJ Joint Repair procedures
Replacement     • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease. • The boot band should be replaced with a new on ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com