Inspection |
1. |
It will be able to diagnose defects of DDM/ADM with GDS
quickly. GDS can operates actuator forcefully, input/output value
monitoring and self diagnosis. |
2. |
Select model and "IPM". |
3. |
Select the "DDM" to check. |
4. |
Select "Input/output monitoring", if you will check current
data of power door lock system. It provides input/output status of
DDM/ADM. |
5. |
If you will check the power door lock operation forcefully, select "Actuation test". |
6. |
To check the DTC of the DDM/ADM module, select "Diagnostic trouble codes" |
Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the front door trim panel.
|
3. |
Disconnect the power window switch module connector (A) from the wiring harness. |
4. |
Remove the power window switch module (B) from the door trim after loosening the mounting screws. |
Installation |
1. |
Install the power window switch module. |
2. |
Install the door trim panel after reconnecting the relevant connectors
|
Canister Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the ventilation hose (A) from the fuel tank air filter.
3.
Disconnect the vapor tube q ...
Smart Cruise Control Switch Repair procedures
Removal and Installation
1.
Disconnect the negative battery cable.
2.
Disconnect the driver air bag module.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
3.
Remove ...
TJ Joint Repair procedures
Replacement
•
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
•
The boot band should be replaced with a new on ...