Inspection |
1. |
It will be able to diagnose defects of IMS with GDS quickly.
GDS can operates actuator forcefully, input/output value monitoring and
self diagnosis. |
2. |
Select model and "IPM - Power seat module". |
3. |
Select "Input/output monitoring", if you will check current
data of body network system. It provides input/output status of each
module. |
4. |
If you will check each module data operation forcefully, select "Actuation test". |
5. |
To check the DTC of the each module, select "DIAGNOSTIC TROUBLE CODES" |
6. |
You can turn ON/OFF of Power seat module option with the "User option" |
7. |
Select the "Data setting" to set the seat position setting when replacing the IMS unit or seat module. |
8. |
Click the "Set". |
9. |
Click the "OK" to complete the set up procedure. |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the door trim (A) after loosening mounting screws.
|
3. |
Remove the memory power seat control switch (A) after loosening connector and screws (3EA) from the door trim. |
Installation |
|
1. |
Install the memory power seat control switch after connecting the switch connector. |
2. |
Install the driver door trim. |
3. |
Install the negative (-) battery terminal. |
Mode Control Actuator Description and Operation
Description
The mode control actuator is located at the heater unit.
It adjusts position of mode door by operating mode control
actuator based on signal of A/C control unit. Pressing mode select ...
Body Control Module (BCM) Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the Reinforcing panel after loosening the ...
Climate Control Air Filter Repair procedures
Replacement
1.
Disconnect the damper (B) from the glove box (A) and then remove the glove box lift (C).
2.
Remove the filter cover(A) with pushing the knob.
3.
Replace the air filter (B), ...