Inspection |
1. |
Open the fuel filler door and remove the fuel filler door release actuator (A) after loosening the mounting bolts. |
2. |
Remove the luggage side trim [LH].
|
3. |
Disconnect the release actuator connector (A). |
4. |
Check for continuity between terminal No.1 and No.2.
If there is no continuity, replace the fuel filler door opener. |
Power Mosfet Repair procedures
Inspection
1.
Ignition "ON"
2.
Manually operate the control switch and measure the voltage of blower motor.
3.
Select the control switch to raise voltage until high speed.
1. Drain2. Dr ...
Smooth cornering
Avoid braking or gear changing in corners, especially when roads are wet. Ideally,
corners should always be taken under gentle acceleration. If you follow these suggestions,
tire wear will be he ...
Front Door Side Weatherstrip Repair procedures
Replacement
1.
Detach the clips, then remove the front door side weatherstrip (A).
2.
Installation is the reverse of removal.
•
Replace any damaged clips.
...