To program a device to HomeLink® using a HomeLink® button previously trained, follow these steps:
1. Press and hold the desired HomeLink® button.DO NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the
HomeLink® button, proceed with "Programming" step 2.
TPMS Sensor Description and Operation
Description
1.
Mode
(1)
Configuration State
A.
All sensors should be in the Low Line state.
B.
In High Line configuration, sensor transmissions occur every 1 minute (nominal) and pressure ...
Body Control Module (BCM) Specifications
Specifications
ItemsSpecificationsRated voltageDC 12VOperating voltageDC 9 ~ 16VOperating temperature-22°F~167°F(-30°C~ 75°C)Dark current5.5mA (SMK : 4.0mA)
...
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST :
For a single wiping cycle, move the lever to the MIST position and release it
with the lever in the OFF position. The wipers will ...