Hyundai Equus Manuals

Hyundai Azera: Repair procedures - Steering wheel - Steering System - Hyundai Azera 2011-2025 Service ManualHyundai Azera: Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Steering System / Steering wheel / Repair procedures

Removal
1.
Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
2.
Turn the steering wheel so that the front wheels can face straight ahead.
3.
Remove the airbag module.
4.
Disconnect the lock nut (A) & connector (B) and then remove the steering wheel by using special service tools. (09561-11001)
Tightening torque : (~2012.09.23)
39.2~44.1N.m(4.0~4.5Kgf.m, 28.9~32.5lb-ft)
Tightening torque : (2012.09.24~)
39.2~49.1N.m(4.0~5.0Kgf.m, 28.9~36.2lb-ft)

   
•
Do not hammer on the steering wheel to remove it; it may damage the steering column.
5.
Installation is the reverse of the removal.
Disaseembly
1.
Loosen the screw(6ea) and remove the lower cover (A) from the steering wheel body.

2.
Disconnect the Wiring (A).

3.
Loosen the screw(2ea) and remove the remote control assembly (A) from the steering wheel body.

4.
Installation is the reverse of the removal.
Components and Components Location
Component 1. Driver airbag (DAB)2. Remote control assembly3. Steering wheel body4. Wiring5. Lower cover ...

Heated Steering wheel Description and Operation
Description The grip is heated as painting heat paint on steering grip for driver convenience for winter Heated control unit Heated pad Specifications ItemSpecificationVoltage13.5 VHeated ...

See also:

Blade replacement
When the wipers no longer clean adequately, the blades may be worn or cracked, and require replacement. CAUTION To prevent damage to the wiper arms or other components, do not attempt to move ...

26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

In-car sensor Repair procedures
Inspection 1. Ignition "ON" 2. Blow warm air into the in-car sensor air inlet. Measure sensor resistance between 2 and 4 terminals. 1. Incar Motor(-)2. Sensor GND3. -4. Incar Sensor (+)5. - ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com