Replacement |
1. |
Remove the rear door module.
(Refer to Rear Door - "Rear Door Module") |
2. |
Disconnect the rear door latch connector (A). |
3. |
Remove the rear door latch assembly (A). |
4. |
Installation is the reverse of removal.
|
Power outlet
The power outlet is designed to provide power for mobile telephones or other
devices designed to operate with vehicle electrical systems. The devices should
draw less than 10 amps with the engine ...
Crankshaft Position Sensor (CKPS) Schematic Diagrams
Circuit Diagram
...
Starter Relay Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay (A).
3.
Using an ohmmeter, check that there is continuity between each terminal.
TerminalContinuity30 - 87NO85 - 86Y ...