Inspection |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the roof trim.
|
3. |
Remove the handsfree mic (A) after disconnect the connector from roof top.
|
4. |
Check the continuity of the Mic between terminals. |
Repair procedures
General Inspection
After or before servicing the EPS system, perform the
troubleshooting and test procedure as follows. Compare the system
condition with normal condition in the table below and ...
Hood Latch Repair procedures
Replacement
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Detach the clips, then remove hood latch cover (A).
3.
Remove the hood latch (A) mounting b ...
Power Seat Control Switch Repair procedures
Inspection
With the power seat switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the power seat switch.
A : Lumb ...