Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the LDWS unit cover (A). |
3. |
Disconnect the LDWS unit connector (A). |
4. |
Remove the LDWS unit after disengaging the mounting bracket (A). |
Installation |
1. |
Align LDWS unit with windshield bracket using forward edge point (A). |
2. |
Engage snaps and pivot upward to lock point (B).
|
3. |
Connect the LDWS unit connector. |
4. |
Connect the negative (-) battery terminal. |
Rear Cross Member Repair procedures
Replacement
1.
Remove the rear wheel & tire (A).
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
•
Be careful not to damage to the hub bo ...
Passenger Airbag (PAB) Module Description and Operation
Description
Passenger Airbag (PAB) module is located in the passenger
crash pad. This PAB contains 2 firing squibs of airbag and 1 firing
squib of active vent. Depending of crash speed or the t ...
Trunk Lid Latch Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Put ...