Inspection |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the crash pad lower panel.
|
3. |
Remove the crash pad side switch assembly. |
4. |
Check the continuity between the switch terminals as the ESC OFF switch is engaged. |
Front Muffler Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Remove the engine room under cover.
3.
Disconnect the heated oxygen sensor (HO2S) connector.
(Refer to Fuel Sys ...
Glass antenna
When the radio power switch is turned on while the ignition switch is in either
the “ON” or “ACC” position, your vehicle will receive both AM and FM broadcast signals
through the antenna in the rear ...
Console Armrest Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Take ...