Hyundai Azera: Line Pressure Control Solenoid Valve Specifications
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Valve Specifications
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Valve Specifications
| Specifications |
Direct control VFS[LINE Pressure]
? Control type : Normal low type
| Control Pressure [kpa (kgf/cm?, psi)] | 500.14 ~ 9.81 (5.1~ 0.1, 72.54 ~ 1.42) |
| Current value(mA) | 50 ~ 850 |
| Internal resistance(?) | 5.1 |
Line Pressure Control Solenoid Valve Description and Operation
Description
Line Pressure(L/P) control solenoid valve is attached to the
valve body. This variable force solenoid valve directly controls the
hydraulic pressure inside the line pressure. ...
Line Pressure Control Solenoid Valve Schematic Diagrams
Circuit Diagram
...
See also:
Repair procedures
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace it.
Horn Relay Inspect ...
GAWR (Gross axle weight rating)
This is the maximum allowable weight that can be carried by a single axle (front
or rear). These numbers are shown on the certification label. The total load on
each axle must never exceed its GAWR. ...
Front Impact Sensor (FIS) Description and Operation
Description
The front impact sensor (FIS) is installed in the Front End
Module (FEM). They are remote sensors that detect acceleration due to a
collision at its mounting location. The primary p ...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com