The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle.
It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.
Press the flasher switch with the ignition switch in any position. The flasher switch is located in the center console switch panel. All turn signal lights will flash simultaneously.
Specifications
Specifications
Front Suspension
ItemSpecificationSuspension typeMacPherson StrutShock absorberTypeHigh Performance Damper (H.P.D)Coil springFree Height [I.D. color] 317.2mm (12.4882 in.) (B ...
Rear Seat Back Cover Repair procedures
Replacement
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and pan ...
Yaw-rate and G Sensor Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the floor console.
(Refer the Body - "Floor console")
3.
Disconnect the yaw rate & latera ...