Remove the overhead console lamp assembly then check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.

No.
| Description
| No.
| Description
|
1
| -
| 4
| Room door
|
2
| GND (-)
| 5
| Mood (+)
|
3
| Door (-)
| 6
| Battery (+)
|


1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the overhead console lamp assembly with removal. |
3. |
Remove the overhead console lamp after disconnecting the panoramaroof switch connector and lamp connector (A). 

|
4. |
If necessary to replace the bulb, replace the bulb (B). |
1. |
Install the overhead console lamp after connecting the panoramaroof switch connector and lamp connector. |
2. |
Install the lens after tightening 2 screws. |
Removal
Room lamp(General type)
1.
Disconnect the negative(-) battery terminal.
2.
Remove the room lamp assembly (A) with (-) screwdriver.
3.
Remove the LED bulb (A).
Room lamp(Panoram ...
Removal
Mood lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
(Refer to Body - "Front Door Trim")
3.
Remove the connector(A) and door LED mood l ...
See also:
Starter Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
2.
Remove the engine room under cover.
3.
Remove the starter cover (A).
Tightening torque :
Bolts: 8.8 ~ 13.7 N. ...
Injector Troubleshooting
Signal Waveform
...
Description and Operation
Description
Remote Keyless Entry System
The described function is a radio-frequency remote control
for central doors locking / unlocking, trunk release and Panic activity
of an automotive vehi ...