Hyundai Azera: Trunk Lid Assembly Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Assembly Repair procedures

Replacement

•	When removing and installing the trunk lid, an assistant is necessary.

•	Wear gloves to protect hands from injury.

1.	After loosening the mounting screws, then remove the trunk inside handle (A).

2.	Detach the clips, then remove the trunk lid trim (A).

3.	Detach the clips, then remove the trunk lid side cover (A).

4.	Disconnect wiring (B) and connectors.

5.

After loosening the mounting bolts, then remove the trunk lid (A).

Tightening torque :

6.9~8.8 N.m (0.7~0.9 kgf.m, 5.1~6.5 lb-ft)

6.

Installation is the reverse of removal.

•	Replace any damaged clips.

Trunk Lid Assembly Components and Components Location

Component Location 1. Trunk lid assembly ...

Trunk Lid Trim Components and Components Location

Component Location 1. Trunk lid trim ...

See also:

Interior care
Interior general precautions Prevent chemicals such as perfume, cosmetic oil, sun cream, hand cleaner, and air freshener from contacting the interior parts because they may cause damage or discolor ...

Hazard Lamp Switch Repair procedures
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the center console upper assembly (A) with hazard lamp switch. Apply the protective tapes to the center ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com