Hyundai Azera: Gate operator & Canadian programming
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Owners Manual / Features of your vehicle / Mirrors / Gate operator & Canadian programming
During programming, your handheld transmitter may automatically stop transmitting. Continue to press the Integrated HomeLink® Wireless Control System button (note steps 2 through 4 in the Standard Programming portion of this document) while you press and re-press ("cycle") your handheld transmitter every two seconds until the frequency signal has been learned. The indicator light will flash slowly and then rapidly after several seconds upon successful training.
Programming
To train most devices, follow these instructions:
1. For first-time programming, press and hold the two outside buttons (
, ), HomeLink® Channel 1 and Channel
3, until the indicator light begins ...
Operating HomeLink®
To operate, simply press and release the programmed HomeLink® button. Activation
will now occur for the trained device (i.e. garage door opener, gate operator, security
system, entry door lock, hom ...
See also:
Shift Lever Repair procedures
Removal
1.
Remove the center console assembly.
(Refer to Body - "Console")
2.
Remove the duct (A).
3.
Disconnect sports mode connector (A).
4.
Remove the shift cable (B).
5.
Remo ...
Accelerator Position Sensor (APS) Description and Operation
Description
Accelerator Position Sensor (APS) is installed on the
accelerator pedal module and detects the rotation angle of the
accelerator pedal. The APS is one of the most important sensors ...
Camshaft Position Sensor (CMPS) Troubleshooting
Wave Form
...
Categories
Hyundai Azera Manuals
