Replacement |
1. |
Remove the hole plug (B). |
2. |
After loosening the mounting bolt, then remove the front door outside handle cover (A).
|
3. |
Remove the front door outside handle (A) by sliding it rearward. |
4. |
Disconnect the front door outside handle connector (A). |
5. |
Installation is the reverse of removal.
|
Steering Angle Sensor Description and Operation
Description
The Steering Angle Sensor (SAS) is installed in MDPS (Motor
Driven Power Steering) and it sends messages to HECU through CAN
communication line.
The SAS is used to determine turnin ...
Fluid Repair procedures
Service Adjustment Procedure
Oil level Check
A check of Automatic Transaxle Fluid(ATF) level is not
normally required during scheduled services. If an oil leak is found, ...
Trunk Lamps Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the luggage room lamp (B) when prying the clip (A) with a flat-up screwdriver.
3.
Remove the luggage room lamp bulb in ca ...