Hyundai Equus Manuals

Hyundai Azera: Description and Operation - Starting System - Engine Electrical System - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Description and Operation

Description
The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.
When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.
The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.
The contacts close and the starter motor cranks. In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

A. Solenoid
B. Brush assembly
C. Armature
D. Overrun clutch

Starting System
...

Repair procedures
Starter Circuit Troubleshooting     The battery must be in good condition and fully charged. 1. Disconnect the injector connectors. 2. With the shift lever in N or P (A/T) ...

See also:

Checking the brake fluid level
Check the fluid level in the reservoir periodically. The fluid level should be between MAX (Maximum) and MIN (Minimum) marks on the side of the reservoir. Before removing the reservoir cap and addin ...

Passenger Airbag (PAB) Module Description and Operation
Description Passenger Airbag (PAB) module is located in the passenger crash pad. This PAB contains 2 firing squibs of airbag and 1 firing squib of active vent. Depending of crash speed or the t ...

Accelerator Position Sensor (APS) Description and Operation
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com