Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel.
|
3. |
Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening the screw. |
Installation |
1. |
Install the coil antenna and connect the 6P connector. |
2. |
Install the crash pad lower panel. |
Variable Intake Solenoid (VIS) Valve Description and Operation
Description
Variable Intake manifold Solenoid (VIS) valves are installed
on the intake manifold (VIS Valve 1) and the surge tank (VIS Valve 2).
These VIS valve 1 and 2 control vacuum modulators ...
Crankshaft Position Sensor (CKPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negat ...
Camshaft Position Sensor (CMPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
•
DON'T remove the camshaft position se ...