When replacing the metal wheels for any reason, make sure the new wheels are equivalent to the original factory units in diameter, rim width and offset.
WARNING
A wheel that is not the correct size may adversely affect wheel and bearing life, braking and stopping abilities, handling characteristics, ground clearance, body-to-tire clearance, snow chain clearance, speedometer and odometer calibration, headlight aim and bumper height.
WARNING - Wheel
Wheels that do not meet HYUNDAI's specifications may fit poorly and result in damage to the vehicle or unusual handling and poor vehicle control.
Mode Control Actuator Repair procedures
Inspection
1.
Ignition "OFF”
2.
Disconnect the connector of mode control actuator.
3.
Verify that the mode control actuator operates to the defrost
mode when connecting 12V to the termin ...
Hood Latch Release Handle Repair procedures
Replacement
1.
Using a screwdriver or remover, remove the hood release handle (A).
•
Use a 6mm hex bit to press the center until the handle easily pulls off the post.
...
Sunvisor Repair procedures
Replacement
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Put on gloves to protect your hands.
1.
Lo ...