Hyundai Azera: Trunk Lid Key Holder Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Key Holder Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Key Holder Repair procedures
| Replacement |
|
| 1. |
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim") |
| 2. |
Disconnect the key holder cable (A), then loosen the key holder (B) mounting bolts and remove.
|
| 3. |
Installation is the reverse of removal. |
Trunk Lid Key Holder Components and Components Location
Component Location
1. Trunk lid key holder
...
Trunk Lid Weatherstrip Repair procedures
Replacement
1.
Remove the trunk lid weatherstrip (A).
•
Do not apply sealant to the body.
2.
Installation is the reverse of removal.
•
...
See also:
CVVT Oil Temperature Sensor (OTS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OTS connector.
3.
Remove the OTS. (Refer to "Removal")
4.
After immersing the thermistor of the sensor into engine coolant ...
In-car sensor Repair procedures
Inspection
1.
Ignition "ON"
2.
Blow warm air into the in-car sensor air inlet. Measure sensor resistance between 2 and 4 terminals.
1. Incar Motor(-)2. Sensor GND3. -4. Incar Sensor (+)5. - ...
Rear Glass Defogger Switch Repair procedures
Inspection
1.
The rear glass defogger switch inputs can be checked using the GDS.
2.
To check the input value of rear glass defogger switch, select option "IPM".
3.
To consult the present ...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com