Hyundai Azera: Specifications
| Specifications |
| Item | Specifications | |
| Transmission type | A6LF2 | |
| Engine model | Gasoline 3.3 GDI | |
| Torque converter type | 3-element, 1-stage, 2-phase type | |
| Torque converter size | O260 mm (10.2362 in.) | |
| Oil pump system | Parachoid | |
| Friction elements | Clutch: 2EA | |
| Brake: 3EA | ||
| OWC : 1EA | ||
| Planetary gear | 3EA | |
| Gear ration | 1st | 4.252 |
| 2nd | 2.654 | |
| 3rd | 1.804 | |
| 4th | 1.386 | |
| 5th | 1.000 | |
| 6th | 0.772 | |
| Reverse | 3.393 | |
| Final gear ratio | 3.041 | |
| Fluid pressure balance piston | 2EA | |
| Accumulator | 4EA | |
| Solenoid valve | 8EA (VFS:6EA, ON/OFF:2EA) | |
| Shift lever position | 4 Range (P,R,N,D) | |
| Oil filter | 1EA | |
VFS: Variable Force Solenoid
Sensors
Input Speed Sensor
? Type: Hall effect sensor
? Specifications
| Operation condition (°C)°F | (-40 ~ 150) -40 ~ 302 | |
| Air gap(mm)in. | (0.95 ~ 1.55) 0.037 ~ 0.0610 | |
| Output voltage(V) | High | 1.18 ~ 1.68 |
| Low | 0.59 ~ 0.84 | |
Output Speed Sensor
? Type: Hall effect sensor
? Specifications
| Operation condition (°C)°F | (-40 ~ 150) -40 ~ 302 | |
| Air gap(mm)in. | (0.55 ~ 1) 0.0217 ~ 0.0394 | |
| Output voltage | High | 1.18 ~ 1.68 |
| Low | 0.59 ~ 0.84 | |
Oil Temperature Sensor
? Type: Negative thermal coefficient type
? Specifications
| Temp.[(°C)°F] | Resistance (k?) |
| (-40)-40 | 48.1 |
| (-20)-4.0 | 15.6 |
| (0)32.0 | 5.88 |
| (20)68.0 | 2.51 |
| (40)104.0 | 1.11 |
| (60)140.0 | 0.61 |
| (80)176.0 | 0.32 |
| (100)212.0 | 0.18 |
| (120)248.0 | 0.10 |
| (140)284.0 | 0.06 |
| (150)302.0 | 0.05 |
Inhibitor Switch
? Type: Combination of output signals from 4 terminals
? Specifications
| Power supply (V) | 12 |
| Output type | Combination of output signals |
Solenoid Valves
Direct control VFS[26/B, T/CON]
? Control type : Normal low type
| Control Pressure [kpa (kgf/cm?, psi)] | 9.81 ~ 500.14 (0.1 ~ 5.1,1.42 ~ 72.54) |
| Current value(mA) | 50 ~ 850 |
| Internal resistance(?) | 5.1 |
Direct control VFS[UD/B, OD/C, 35R/C]
? Control Type : Normal high type
| Control Pressure [kpa (kgf/cm?, psi)] | 500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42) |
| Current value(mA) | 50 ~ 850 |
| Internal resistance(?) | 5.1 |
Line Pressure Control VFS
? Control type : Normal high type
| Control Pressure [kpa (kgf/cm?, psi)] | 500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42) |
| Current value(mA) | 50 ~ 850 |
| Internal resistance(?) | 5.1 |
ON/OFF Solenoid Valve(SS-A, SS-B)
? Control type : Normal low type
| Control pressure [kpa (kgf/cm?, psi)] | 490.33(5.0, 71.12) |
| Internal resistance(?) | 10 ~ 11 |
Solenoid Valve Operation Table
| SS-A | SS-B | UD/B-VFS | OD/C-VFS | 35R/C-VFS | 26/B-VFS | |
| N/H | N/H | N/H | N/L | |||
| N, P | ? | ? | ? | |||
| 1 | ? | ? | ? | |||
| 2 | ? | ? | ? | |||
| 3 | ? | ? | ||||
| 4 | ? | |||||
| 5 | ? | ? | ||||
| 6 | ? | ? | ? | |||
| L | ? | ? | ||||
| R | ? | ? | ? |
? : Connected status
? : Connected at vehicle speed above 8km/h
Tightening Torques
| Item | N.m | Kgf.m | lb-ft |
| TCM installation mounting bolt | 9.8 ~ 11.8 | 1.0 ~ 1.2 | 7.2 ~ 8.7 |
| Shift cable bracket mounting bolt | 14.7 ~ 21.6 | 1.5 ~ 2.2 | 10.0 ~ 15.9 |
| Input shaft speed sensor mounting bolt | 9.8 ~ 11.8 | 1.0 ~ 1.2 | 7.2 ~ 8.7 |
| Output shaft speed sensor mounting bolt | 9.8 ~ 11.8 | 1.0 ~ 1.2 | 7.2 ~ 8.7 |
| Shift lever assembly bolt | 8.8 ~ 13.7 | 0.9 ~ 1.4 | 6.5 ~ 10.1 |
| Inhibitor switch mounting bolt | 9.8 ~ 11.8 | 1.0 ~ 1.2 | 7.2 ~ 8.7 |
| Valve body cover mounting bolt | 13.8 ~ 14.7 | 1.3 ~ 1.5 | 9.4 ~ 10.8 |
| Eyebolt | 4.9 ~ 5.9 | 0.5 ~ 0.6 | 3.6 ~ 4.3 |
| Oil drain plug | 34.3 ~ 44.1 | 3.5 ~ 4.5 | 25.3 ~ 32.6 |
| Torque converter mounting bolt | 45.1 ~ 52.0 | 4.6 ~ 5.3 | 33.3 ~ 38.3 |
| Automatic transaxle upper mounting bolt (TM=>Eng) | 63.7 ~ 83.4 | 6.5 ~ 8.5 | 47.0 ~ 61.5 |
| 32.4 ~ 53.9 | 3.3 ~ 5.5 | 23.9 ~ 39.8 | |
| Automatic transaxle lower mounting bolt (Eng=>TM) | 39.2 ~ 46.1 | 4.0 ~ 4.7 | 28.9 ~ 34.0 |
| 78.5 ~ 98.1 | 8.0 ~ 10.0 | 57.9 ~ 72.3 | |
| Automatic transaxle support bracket bolt | 88.3 ~ 107.9 | 9.0 ~ 11.0 | 65.1 ~ 79.6 |
| Lubricants |
| Item | Specified lubricant | Quantity |
| Transaxle fluid | SK ATF SP-?, MICHANG ATF SP-?, NOCA ATF SP-?, Hyundai Genuine ATF SP-? or other brands meeting the above specification approved by Hyundai Motors Corp. | 7.8L (2.06 U.S gal., 8.24 U.S.qt., 6.86 Imp.qt.) |
Sealant
| Item | Specified sealant |
| Rear cover | LOCTITE FMD-546 or THREE-BOND TB1281B |
| Torque converter housing |
Special Service Tools
Special Service Tools
Tools(Number and name)IllustrationUse09200-38001, 09200-3N000Engine support fixture (Beam)Removal and installation of the transaxle.Except
lower supporter, use beam only w ...
See also:
Tires and wheels
✽ NOTICE
It is permissible to add 3psi to the standard tire pressure specification
if colder temperatures are expected soon. Tires typically loose 1psi for every 12°F
temperature drop. If ...
SS-B Solenoid Valve(ON/OFF) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valver connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Rear Package Tray Trim Repair procedures
Replacement
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and pan ...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com