Description |
Never attempt to measure the circuit resistance of the Seat
Belt Pretensioner (BPT) even if you are using the specified tester. If
the circuit resistance is measured with a tester, the pretensioner will
be ignited accidentally. This will result in serious personal injury. |
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Recommended cold tire inflation pressures
All tire pressures (including the spare) should be checked when the tires are
cold. “Cold Tires” means the vehicle has not been driven for at least three hours
or driven less than 1 mile (1.6 km).
...
Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams
Circuit Diagram
...