Open the hood after turning off the engine on a flat surface, move the shift lever to the P(Park) position and set the parking brake.
1. Pull the release lever to unlatch the hood. The hood should pop open slightly.
2. Go to the front of the vehicle, raise the hood slightly, pull up the secondary
latch (1) inside of the hood center and lift the hood (2).
3. Raise the hood. It will raise completely by itself after it has been raised about
halfway.
Parking Brake Pedal Assembly Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
3.
Remove the junction b ...
Steering gear box, linkage & boots/lower arm ball joint
With the vehicle stopped and engine off, check for excessive free-play in the
steering wheel.
Check the linkage for bends or damage. Check the dust boots and ball joints for
deterioration, cracks, ...
Engine And Transmission Assembly Repair procedures
Removal
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
...