Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the center console upper assembly (A) with hazard lamp switch.
|
3. |
Remove the heater control unit (A). |
4. |
Disconnect the heater control unit connector (A). |
Installation |
1. |
Install the heater control unit. |
2. |
Install the center console upper assembly. |
In-car sensor Repair procedures
Inspection
1.
Ignition "ON"
2.
Blow warm air into the in-car sensor air inlet. Measure sensor resistance between 2 and 4 terminals.
1. Incar Motor(-)2. Sensor GND3. -4. Incar Sensor (+)5. - ...
Water pump Troubleshooting
Troubleshooting
SymptomsPossible CausesRemedyCoolant leakage
•
From the bleed hole of the water pump
Visually check
•
Check leaks after about ten-minute warming up.
•
If coolant st ...
ICM (Integrated Circuit Module) Relay Box Schematic Diagrams
Circuit Diagram
...