Hyundai Azera: Parking Brake Cable Repair procedures
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Brake System / Parking Brake System / Parking Brake Cable Repair procedures
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Brake System / Parking Brake System / Parking Brake Cable Repair procedures
| Removal |
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
| 2. |
Remove the crash pad lower panel.
|
| 3. |
Remove the parking brake cable mounting nuts (A).
|
| 4. |
Remove the parking brake cable adjusting nut(A) and the fixing clip(B), and then remove the parking brake pedal.
|
| 5. |
Remove the floor console.
|
| 6. |
Remove the shift lever assembly.
|
| 7. |
Remove the parking brake cable (B) after removing the cable retainer (A).
|
| 8. |
Remove the parking brake cable fixing clip (A) and bolts. And then remove the front parking brake cable.
|
| 9. |
Raise the vehicle, and make sure it is securely supported. |
| 10. |
Remove the rear wheel & tire. |
| 11. |
Remove the parking brake cable (B) after removing the fixing clip (A).
|
| 12. |
Loosen the parking brake cable bracket bolts and remove the rear parking brake cable. |
| 13. |
Installation is reverse of removal. |
Parking Brake Pedal Assembly Repair procedures
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash pad lower panel")
3.
Remove the junction b ...
See also:
Headlight, position light, turn signal light, front fog light bulb replacement
(1) Headlight (High) / DRL (Daytime running light)
(2) Headlight (Low)
(3) Front turn signal light
(4) Position (Parking) light
(5) Front side marker
(6) Front fog light
WARNING - Halogen bu ...
General Safety Information and Caution
Smart Cruise Control
Be careful when driving the vehicle using the smart cruise control system as follows.
•
The smart cruise control system may have limits to detect dist ...
Repair procedures
Inspection
Check it by the procedure below to see if the function of the ECM is normal.
1.
Turn the ignition key to the "ON" position.
2.
Cover the front sensor to stop functioning.
3.
Sh ...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com