Storing driver’s seat positions
1. Shift the shift lever into P (Park) while the ignition switch is ON.
2. Adjust the driver’s seat, outside rearview mirror, steering wheel position and
instrument panel illumination intensity comfortable to the driver.
3. Press the SET button on the control panel. The system will beep once.
4. Press one of the memory buttons (1 or 2) within 5 seconds after pressing the
SET button. The system will beep twice when memory has been successfully stored.
5. "Driver 1(or 2) set is memorized" will appear on the instrument cluster LCD display.
Recalling positions from memory
1. Shift the shift lever into P (Park) while the ignition switch is ON.
2. To recall the position in memory, press the desired memory button (1 or 2). The
system will beep once, then the driver’s seat, outside rearview mirror, steering
wheel and the instrument panel illumination will automatically adjust to the stored
positions.
3. "Driver 1 (or 2) set is changed" will appear on the instrument cluster LCD display.
Adjusting the control switch for the driver’s seat, outside rearview mirror, steering wheel and the instrument panel illumination while the system is recalling the stored position will cause the movement to stop and move in the direction that the control switch is moved.
Operation of the rear parking assist system
Operating condition
This system will activate when backing up with the ignition switch ON.
The sensing distance while the rear parking assist system is in operation
is approximately 47 in. (12 ...
Body Control Module (BCM) Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the Reinforcing panel after loosening the ...
Tire replacement
If the tire is worn evenly, a tread wear indicator will appear as a solid band
across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left
on the tire. Replace the tire when t ...