Underdrive brake control solenoid valve(UD/B) is attached to
the valve body. This variable force solenoid valve directly controls the
hydraulic pressure inside the underdrive brake.

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Specifications
Direct control VFS[UD/B]
? Control type : Normal low type
Control Pressure [kpa (kgf/cm?, psi)] 500.14 ~ 9.81(5.1 ~ 0.1, 72.54 ~ 1.42)Current value(mA)50~850 Internal resis ...
See also:
Shift Cable Repair procedures
Removal
1.
Remove the center console assembly.
(Refer to Body - "Console")
2.
Remove the duct (A).
3.
Remove the control cable (B).
4.
Remove the control cable assembly in the vehicle ...
Components and Components Location
Component Location
...
Winter driving
Severe weather conditions in the winter result in greater wear and other problems.
To minimize the risks of winter driving, you should follow these suggestions: ...