Hyundai Azera: Fuel Filler Cap Description and Operation
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Filler Cap Description and Operation
Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Filler Cap Description and Operation
| Description |
A ratchet tightening device on the threaded fuel filler cap
reduces the chances of incorrect installation, which would seal the fuel
filler. After the gasket on the fuel filler cap and the filler neck
flange contact each other, the ratchet produces a loud clicking noise
indicating the seal has been set.
| 1. Cover 2. Torsion spring 3. Retainer 4. Gasket seal | 5. Spring 6. Plate seal 7. Vacuum valve 8. Spring |
On-board Refueling Vapor Recovery (ORVR) valve Repair procedures
Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel tank.
(Refer to Fuel System - "Fuel Tank")
3.
Disconnect the vapor hose (A).
4.
Remove ...
Fuel Tank Air Filter Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the v ...
See also:
Front Impact Sensor (FIS) Components and Components Location
Components
...
Water Jacket Seperator Repair procedures
Removal
1.
Remove the LH/RH cylinder head assembly and gasket.
(Refer to Cylinder Head Assembly - "Cylinder Head")
2.
Remove the water jacket seperator (A).
Installation
1.
Install the ...
Rear Back Armrest Repair procedures
Replacement
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and pan ...
Categories
Hyundai Azera Manuals
© 2011-2025 Copyright www.hgmanual.com