Inspect Glass Alignment
1. |
Check for abnormal noise or bending during operation. |
2. |
With the sunroof fully closed, check for water leakage. |
3. |
The roof panel (B) should be even with the movable glass (A)
weatherstrip, to within the standard value "E" all the way around. If
not, make the following adjustment.
Tightening torque :
Standard value "E" [mm(in.)]
(1) Front edge : 1.2 mm (0.0472 in.)
(2) Rear edge : 1.0 mm (0.0394 in.)
|
|
4. |
If the position is not as specified, lightly loosen the glass adjusting screws (A) to adjust the glass height and tighten it.
• |
Do not damage the screws. |
|
|
Operating The Panoramaroof Emergency Handle
1. |
Use the panoramaroof emergency handle to close and open the panoramaroof manually for the following case only.
A. |
To close the panoramaroof before driving a vehicle in a rainy
day or on the highway if the panoramaroof can not be closed due to
failure of the panoramaroof motor or controller. |
|
2. |
Operating method.
B. |
Push the emergency handle up into the hexagonal drive of the
panoramaroof motor. You must push hard enough to disengage the motor
clutch; otherwise the emergency handle will slip due to incomplete fit
in the motor. |
C. |
Carefully turn the emergency handle clockwise to close the panoramaroof. |
D. |
After closing the sunroof, wiggle the handle back and forth
as you remove the tool from the motor, to ensure the motor clutch
reengages. |
E. |
A 5mm hex socket may be used in place of the emergency handle, with a” Speeder” type handle. |
• |
Do not use power tools to operate the panoramaroof. |
• |
Damaged to the components may occur. |
|
|
Components (1)
1. Roof side molding [RH]2. Roof side molding [LH]3. Movable glass assembly4. Wind deflector assembly5. Panoramaroof panel assembly6. Folding cover [RH]7. Decoration cover [RH]8. D ...
Replacement
1.
Open the movable glass fully.
2.
Remove the folding cover (A).
3.
After loosening the mounting screws, then remove the movable glass (A).
•
Do not ...
See also:
Front Pillar Trim Repair procedures
Replacement
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and pan ...
Instrument Cluster Repair procedures
Inspection
Speedometer
1.
Adjust the pressure of the tires to the specified level.
2.
Drive the vehicle onto a speedometer tester. Use wheel chocks (A) as appropriate.
3.
Check if the spe ...
Using the Room Mirror Key
Selecting the room mirror key will allow you to make service required inquiries,
POI info searches, and emergency rescues by connecting to the Blue Link® Center.
Such features can be used only after ...