Hyundai Azera: Fuel Tank Pressure Sensor (FTPS) Description and Operation

Accelerator Position Sensor (APS) Repair procedures

Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output voltage of the APS 1 and 2 at C.T and W.O.T. Specification: Refer t ...

Fuel Tank Pressure Sensor (FTPS) Specifications

Specification Pressure [kPa (kgf/cm?, psi)]Output Voltage (V)-6.67 (-0.06, -0.97)0.502.5+6.67 (0.068, 0.97)4.5 ...

See also:

Repair procedures
Inspection (With GDS) 1. Check BCM input/output specification of multifunction switch using the GDS. If the specification is abnormal, replace the lamp or wiper switch. 2. If diagnosis is ...

Seat Belt Buckle Switch (BS) Description and Operation
Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status inp ...

Glass antenna
When the radio power switch is turned on while the ignition switch is in either the “ON” or “ACC” position, your vehicle will receive both AM and FM broadcast signals through the antenna in the rear ...