Removal |
1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”) |
2. |
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B). |
3. |
Remove the cushion pipe fixing clip (A), and then separate the head assembly (B) from reservoir cup. |
4. |
Remove the return nozzle (B) after releasing the fixing hook (A). |
5. |
Remove the reservoir-cup (B) after releasing the fixing hooks (A). |
6. |
Remove the pre-filter (C) after releasing the fixing hooks (A,B)
|
7. |
Remove the fuel pressure regulator (A) in the direction. |
Installation |
1. |
Installation is reverse of removal. |
Exhaust Manifold Repair procedures
Removal and Installation
[LH]
1.
Disconnect the LH front and rear heated oxygen sensor (HO2S) connector.
(Refer to Fuel System - "Heated Oxygen Sensor (HO2S)")
2.
Remove the front muffler ...
Closing the trunk
To close, lower the trunk lid, then press down on it until it locks. To be sure
the trunk lid is securely fastened, always check by trying to pull it up again.
Once the trunk is opened and then clos ...
Compressor Repair procedures
Removal
1.
If the compressor is marginally operable, run the engine at
idle speed, and let the air conditioning work for a few minutes, then
shut the engine off.
2.
Disconnect the negati ...