Hyundai Azera: Door Scuff Trim Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Body (Interior and Exterior) / Interior Trim / Door Scuff Trim Repair procedures

Replacement

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

•	Put on gloves to protect your hands.

1.	Using a screwdriver or remover, remove the front door scuff tirm (A). [Front]

2.	Disconnect the connector (A).

3.	Remove the rear seat cushion assembly. (Refer to Rear Seat - "Rear Seat Assembly")

4.	After loosening the mounting screw, then remove the rear door scuff trim (A). [Rear]

5.	Disconnect the connector (A).

6.

Installation is the reverse of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Door Scuff Trim Components and Components Location

Component Location 1. Front door scuff trim2. Rear door scuff trim ...

Cowl Side Trim Components and Components Location

Component Location 1. Cowl side trim ...

See also:

Components and Components Location
Components Location 1. Overdrive clutch (OD/C)2. One way clutch (OWC)3. Low & Reverse brake (LR/B)4. Underdrive brake (UD/B)5. 26 brake(26/B)6. 35R clutch (35R/C)7. Damper clutch (D/C) ...

SRS care
The SRS is virtually maintenance-free and so there are no parts you can safely service by yourself. If the SRS air bag warning light ( ) does not illuminate when you turn the ignition ON, or if it ...

Evaporator Temperature Sensor Repair procedures
Inspection 1. Ignition "OFF". 2. Disconnect evaporator temperature sensor. 3. Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor. Spe ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com