Windshield deicer system prevent windshield wiper from
freezing in the winter season. It consists of deicer in the lower part
of windshield, switch and relay. IPM receives an input signal from the
deicer switch, then controls relay. Operating condition is the same that
of rear window defogger system.
Since the generator "L" is switched ON, if the deicer switch is ON, then deicer output is ON for 20 minutes.
Component Location
1. Windshield deicer relay (Built-in engine room relay box)2. Windshield deicer switch (Rear glass defogger switch)3. Windshield deicer4. Deicer connector
...
Inspection
1.
Remove the cowl top cover.
(Refer to Windshield Wiper/Washer - "Front Wiper Motor")
2.
Disconnect the windshield deicer connector from the wiper motor linkage.
3.
Check for ...
See also:
Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST :
For a single wiping cycle, move the lever to the MIST position and release it
with the lever in the OFF position. The wipers will ...
Components and Components Location
Component Location
1. Seat Memory Unit (IMS)2. IMS control switch3. IMS driver power seat control
...
Fuel Pump Repair procedures
Inspection
[Fuel pump]
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump assembly.
3.
Check motor operation by fuel pump connector (A) connecti ...