This consumer information has been prepared in accordance with regulations issued by the National Highway Traffic Safety Administration of the U.S. Department of Transportation.
Your Hyundai dealer will help answer any questions you may have as you read this information.
Hyundai motor vehicles are designed and manufactured to meet or exceed all applicable safety standards.
For your safety, however, we strongly urge you to read and follow all directions in this Owner's Manual, particularly the information under the headings "NOTICE", "CAUTION" and "WARNING".
If, after reading this manual, you have any questions regarding the operation of your vehicle, please contact your nearest Hyundai Motor America Regional Office as listed in the following:
Eastern Region:
Connecticut, Delaware, Maine, Massachusetts, New Hampshire, New Jersey, New York, Pennsylvania, Rhode Island, Vermont.
Eastern Region 1122 Cranbury South River Road Jamesburg, NJ 08831 (800) 633-5151
Southern Region:
Florida, Georgia, Maryland, North Carolina, South Carolina, Virginia, West Virginia.
Southern Region 3025 Chastain Meadows Parkway suite 100 Marietta, GA 30066 (800) 633-5151
South Central Region:
Alabama, Arkansas, Louisiana, Mississippi, New Mexico, Oklahoma, Tennessee, Texas.
South Central Region 1421 South Beltline Road, Suite 400 Coppell, TX 75019 (800) 633-5151
Central Region:
Illinois, Indiana, lowa, Kentucky, Michigan, Minnesota, Nebraska, North Dakota, South Dakota, Ohio, Wisconsin, Kansas, Missouri.
Central Region 1705 Sequoia Drive Aurora, Illinois 60506 (800) 633-5151
Western Region:
Alaska, Arizona, California Colorado, Hawaii, ldaho, Montana, Nevada, Oregon, Utah, Washington, Wyoming.
Western Region 10550 Talbert Avenue P.O.Box 20850 Fountain Valley, California 92728-0850 (800) 633-5151
Idler Components and Components Location
Components
1. Idler
...
Variable Intake Solenoid (VIS) Valve Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between the VIS valve terminals 1 and 2.
4.
Check that the resistance is within ...
Starter Relay Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay (A).
3.
Using an ohmmeter, check that there is continuity between each terminal.
TerminalContinuity30 - 87NO85 - 86Y ...