Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and
detects the piston position of each cylinder which the CKPS can't
detect.
The two CMPS are installed on engine head cover of bank 1 and
2 respectively and uses a target wheel installed on the camshaft. The
Cam Position sensor is a hall-effect type sensor. As the target wheel
passes the Hall sensor, the magnetic field changes in the sensor. The
sensor then switches a signal which creates a square wave.
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negat ...
Specification
ItemSpecificationOutput Voltage (V)High: 5.0VLow: 0.7VAir Gap (mm)0.5 ~ 1.5
...
See also:
Water pump Troubleshooting
Troubleshooting
SymptomsPossible CausesRemedyCoolant leakage
•
From the bleed hole of the water pump
Visually check
•
Check leaks after about ten-minute warming up.
•
If coolant st ...
Accelerator Pedal Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Remove the installation nuts (B) and ...
Vehicle weight
This section will guide you in the proper loading of your vehicle, to keep your
loaded vehicle weight within its design rating capability. Properly loading your
vehicle will provide maximum return o ...