Hyundai Equus Manuals

Hyundai Azera: Ambient Sensor Repair procedures - Air Conditioning System - Heating,Ventilation, Air Conditioning - Hyundai Azera 2011-2025 Service ManualHyundai Azera: Ambient Sensor Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / Ambient Sensor Repair procedures

Inspection
1.
Ignition "OFF"
2.
Disconnect ambient temperature sensor.
3.
Check the resistance of ambient temperature sensor between terminals 1 and 2 whether it is changed by changing of the ambient temperature.

1. Sensor Ground
2. Ambient Sensor Signal

Specification
Ambient temperature
[°C(°F)]
Resistance between terminals 1 and 2 (k?)
-30(-22)
480.41
-20(-4)
271.21
-10(14)
158.18
0 (32)
95.10
10 (50)
58.80
20 (68)
37.32
30(86)
24.26
40(104)
16.13
50(122)
10.95

4.
If the measured resistance is not specification, substitute with a known-good ambient temperature sensor and check for proper operation.
5.
If the problem is corrected, replace the ambient temperature sensor.
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the under cover (A).

3.
Disconnect the connector and then remove the ambient temperature sensor (A).

4.
Installation is the reverse order of removal.
Ambient Sensor Description and Operation
Description 1. The ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor resistance will increase with lower ...

Cluster ionizer Components and Components Location
Component location ...

See also:

3. Exhaust emission control system
The Exhaust Emission Control System is a highly effective system which controls exhaust emissions while maintaining good vehicle performance. Vehicle modifications This vehicle should not be modifi ...

Front Door Trim Repair procedures
Replacement     • Be careful not to scratch the door trim and other parts. • Put on gloves to protect your hands. 1. Using a screwdriver or remover, remove the fro ...

In-car sensor Repair procedures
Inspection 1. Ignition "ON" 2. Blow warm air into the in-car sensor air inlet. Measure sensor resistance between 2 and 4 terminals. 1. Incar Motor(-)2. Sensor GND3. -4. Incar Sensor (+)5. - ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com